I have the simple network shown in the attached picture. The N6SER-100 node is a WRT54G v2 and my node, WA6PZB-100 is a WRT54GS v2. The issue is that while I am connected to the LAN port on N6SER-100 with the PC, I cannot view the status page either via localnode:8080 or N6SER-100:8080 or via any of the combinations of FQDN and IP address URLs. However I can access N6SER-100 from the PC connected to the LAN port of the WA6PZB-100 node. I can ping localnode on the PC connected to N6SER-100 and can even SSH to it via the LAN port. Very weird, I did not have this issue with v1.0.0  firmware.

Attachments
 mesh.jpg [53 KB] :: Diagram

When plugged into N6SER are you receiving an IP address ?

You may be hitting the issue being described http://www.broadband-hamnet.org/hsmm-mesh-forums/view-postlist/forum-3-firmware/topic-1038-v10x-to-v112-one-pc-discovered-other-not.html#ccbp4636

Hi Conrad,

Thanks for the reply. Yes, I am getting an IP address via DHCP. I have also now verified the /etc/config/firewall settings. They are the same on both nodes.

73, -Dan

Hello again,

There is a connection to DHCP with this issue after all. I tried an older Dell laptop with a 3COM NIC and it will not get an IP address even though my other laptop does. I have also tried using static IPs and gateways, this allows me to get to everything on the network (including SSH to localnode) except to http://localnode:8080. I reverted the N6SER-100 node back to the v1.0.0 firmware and all the issues are gone, even with the older Dell laptop.

I have reverted all my nodes now to v1.0.0 of the firmware and I am sure the cause of this issue will be found. If I can help in anyway let me know.

Thank you all for the development of HSMM and the support.

73, -Dan